Fly-Super5 Pro Klipper host CANbus configuration
Edit me

Klipper Host CAN0 file configuration

  • SSH to your Klipper host and create a new can0 file in the /ect/network/interfaces.d folder
     sudo nano /etc/network/interfaces.d/can0
  • Enter the following information.
    allow-hotplug can0
    iface can0 can static
     bitrate 500000
     up ifconfig $IFACE txqueuelen 1024
     pre-up ip link set can0 type can bitrate 500000
     pre-up ip link set can0 txqueuelen 1024
  • Enter Ctrl+X to save the can0 file

  • Reboot your klipper host.

  • This should be all you need to do if you are using a Fly UTOC-1, UTOC-3 or Fly-Super 5 Pro in USB to CAN bridge mode. Other CAN bus adapters may need aditional configuration steps.