The SHT-42 board uses CAN communication to connect the host computer with the UTOC board, other USB to CAN adapters, Pi Hats or USB. For USB use it is recommended to not to use a cable that exceeds 1 meter ( 3.2 feet ) The optional 31865 chip supports PT100 temperature sensors for improved accuracy.
CAN bus connection for stable data transmission over long distaces.
24 volt max input
5 amp mosfet for heater control
Onboard TMC2209 driver for the extruder
Onboard ADXL345 accelerometer to measure resonance for input shaper.
Support PT100 (MAX31865)
Replaceble fan MOS that supports 2 controllable fans.
RGB Led control
Peripheral interface:USB1, CAN1, FAN2, RGB1, Servo1, Probe1, EndStop3, PT100 4 line1(optional), Thermal1, Heater1
- SHT-42 Board
- Heatsink for 2209 driver
- Jumpers * 3
- JST-XH plug and Female Crimp Terminals
- JST-PH plugs and Female Crimp Terminals
- Microfit 3.0 4 position plug and Female Crimp Terminals
- Fan MOS
- USB-A to USB-C Cable