Fly-Super8Pro H723 Klipper host CANbus configuration

Edit me

Klipper Host CAN0 file configuration

Important: This guide assumes you have a working Klipper host installation on a Fly Gemini, Fly Pi, Raspberry Pi or compatible device. If you don’t have a working installation, please use kiauh

SSH to your Klipper host and create a new can0 file in the /ect/network/interfaces.d folder
```
 sudo nano /etc/network/interfaces.d/can0
```

Enter the following information.

allow-hotplug can0
iface can0 can static
 bitrate 500000
 up ifconfig $IFACE txqueuelen 1024
 pre-up ip link set can0 type can bitrate 500000
 pre-up ip link set can0 txqueuelen 1024

Note: Use the same bitrate you use on your can tool boards. This can be 250000, 500000 or 1000000. Bitrates of 500000 and 1000000 are prefered.

Enter Ctrl+X to save the can0 file
Reboot your klipper host.
This should be all you need to do if you are using a Fly UTOC-1, UTOC-3 or Fly-Super8Pro H723 in USB to CAN bridge mode. Other CAN bus adapters may need aditional configuration steps.

Links

Tags: