How to compile and updating the klipper firmware running on a Fly-Super5Pro in USB mode
Edit me
Configuring and installing Klipper for USB
Compile Klipper firmware for Fly-Super5Pro
Tip: To read more about the KCONFIG_CONFIG option, see here
- ssh to your klipper host console
-
cd to the klipper directory
cd ~/klipper -
Run make clean
make clean KCONFIG_CONFIG=config.super5pro
Important: If when running the above command you get this output
Then you need to set all the correct settings when running make menuconfig below.
Otherwise, skip to compiling klipper.
Using default symbol values (no 'config.super5pro'). Configuration saved to 'config.super5pro' Then you need to set all the correct settings when running make menuconfig below.
Otherwise, skip to compiling klipper.
-
Open menuconfig
make menuconfig KCONFIG_CONFIG=config.super5pro - Set the following settings
- [*] Enable extra low-level configuration options
- Micro-controller Architecture (STMicroelectronics STM32)
- Processor model (STM32H723)
- Bootloader offset (128KiB bootloader (SKR SE BX v2.0))
- Clock Reference (25 MHz crystal)
- Communication interface (USB (on PA11/PA12))
- USB ids
-
() GPIO pins to set at micro-controller startup
Klipper Menu Config USB
- Quit and save the configuration
-
Run Make to compile the firmware
make KCONFIG_CONFIG=config.super5pro -j4
Flash Klipper USB firmware with Katapult over USB
-
Look in your printer.cfg file and make note of the serial ID for your board.
-
Run the make flash command to flash the firmware
make KCONFIG_CONFIG=config.super5pro flash FLASH_DEVICE= {Your serial ID here } -
Example
make KCONFIG_CONFIG=config.super5pro flash FLASH_DEVICE=/dev/serial/by-id/usb-katapult_stm32f407xb_170038000650314D35323820-if00
Burn Klipper firmware over USB -
Your Fly-Super5Pro should now have klipper firmware updated and be ready to use again.
