General information regarding the Fly-ERCF-Easy-BRD-V1.1
Edit me

Fly-ERCF-Easy-BRD-V1.1 Overview

Description

The Fly-ERCF-Easy-BRD-V1.1 toolboard uses CAN communication to connect the host computer with a UTOC board, other USB to CAN adapters, Pi Hats, USB to CAN Bridge Mode in Klipper or USB. For USB use it is recommended to not to use a cable that exceeds 1 meter ( 3.2 feet ) in length.
The Fly-ERCF-Easy-BRD-V1.1 is available from AliExpress

Fly-ERCF-Easy-BRD-V1.1 Front and Rear view
Fly-ERCF-Easy-BRD-V1.1 Front and Rear view

Product Features

  • CANbus connection for stable data transmission over long distaces.
  • 24 volt max input
  • 5 amp mosfet for heater control
  • SPI/UART Driver Support
  • Peripheral interface:USB1, CAN1, Servo1, Probe1, EndStop1, Encoder1
  • 5V anti-backflow
Fly-ERCF-Easy-BRD-V1.1 dimensions
Fly-ERCF-Easy-BRD-V1.1 dimensions

Driver Jumpers

The jumpers should be installed as below. “Common Interpolation” should be used for standalone drivers. “SPI mode Interpolation” is supported for TMC5160 drivers. “UART mode Interpolation” should be used when using smart drivers (i.e. TMC2208, TMC2209, TMC2225 and TMC2226)

BOM

Fly-ERCF-Easy-BRD-V1.1 Driver Jumper Locations
Fly-ERCF-Easy-BRD-V1.1 Driver Jumper Locations

Included parts

  • Fly-ERCF-Easy-BRD-V1.1 Board
  • Jumpers * 9
  • JST-XH plugs and Female Crimp Terminals
  • XT30+2 3 meter 4 wire harness
  • USB-A to USB-C Cable
Tags: