General information regarding the Fly-DP5
Edit me
Fly-DP5 General Information
Overview
This page covers any general information for the Fly-DP5 board. It is currently available through AliExpress.
Features
- MCU: STM32F072RBT6
- Firmware: Klipper
- Supports 12-24V DC power supply, which makes the power supply more stable and eliminates the need for step-down modules.
- Driver working mode support: SPI, UART, STEP/DIR
- Support driver: supports external TMC5160Pro, TMC5160, TMC2209, TMC2225, TMC2226, TMC2208, TMC2130, A4988, etc.
- Expansion interface: BLTouch (Servos, Probe), UART X1, 12864 X1
- Fans: Two-wire controllable fan X2, parallel fan X2, normally open fan X2
- Temperature sensor: 2-way NTC 100K
- Supported machine structures: Cartesian, Delta, Kossel, Ultimaker, CoreXY
- The new plug-in driver can prevent the driver from being connected reversely
Driver Jumpers
There are no jumpers to install with the 2209 drivers.
Driver Diag Pin
The driver diag pin is used for sensorless homing and stall detection. To enable the diag pin, add a jumper as shown in the image below.
Input voltage
The board can handle an input voltage up to 32v.
Initial Installation
The board that you will receive doesn’t have any firmware installed so when plugged into a computer, the board will show as an unidentified device.
Dimensions
